This is revised version of the original Montan mask as available on the feature page www.makethemasks.com
What are the changes:
I wated a model that really prints without supports and that is not so ressource hungry.
If you already printed the original from Makethemasks or one of the clones you might have noticed the really bad mounts for the elastic bands.
So I removed the bad overhangs and adjusted the angle of the underside so it will no longer print in mid air.
Should result in a much cleaner print and easier cleaning after daily use.
Simplyfied and reduced the mesh for a much smaller file of under 1mb.
Recommended print settings:
PLA
0.1mm layer height
15% infill, honeycomb or triangular
Infill every 3 layers to save time and provide better layer adhesion
6 solid top and bottom layers at least
3 perimeters - it works with 2 but can cause very thin walls in the nose and chin area, 3 should be prefered