RedBull 2019 Front wng and suspension with wheel, object comes as an OBJ so you have an easier time converting to CAD to run Computational fluid dynamics tests on it. Object scale is 1:1 and was produced entirely by myself, i’ve connected the front wing nose wind induction into the S DUCT but this is easily replaceable with a traditional S duct below the nose in the low pressure zone. I’ve also got a bargeboard section in the works but it is not ready for release yet. Furthermore, if you wish to do a CAD creation of this i would hope you show me your results, i’ve ran my own personal simulations but i would like to see other peoples simulations too.