Gyro Zeppeli Belt Buckle [JJBA - Part 7]

REUPLOADED due to design flaw, now fixed. IMPORTANT For scale: the long edge of the buckles should be 5 inches long from tip to tip (4 works, but it may be a bit small for cosplay). The model should already be at a height of 5 inches if you were to stand it with the long edge running up the Z axis (Longer than the edge itself). I recommend printing with 4 layers to the shell at minimum for the most reliable results (tested). Details: Fully functioning, cosplay ready belt buckles as seen on Gyro Zeppeli's design from Jojo's Bizarre Adventure: Steel Ball Run. Based off the clasp mechanism as seen in the manga. I originally made these for my own cosplay, but seeing that the only printable models were held in monopoly by an etsy artist, I felt I could make better, more accurate models and make them open source for hobbyists, cosplayers, and diy enthusiasts such as myself. I hope you enjoy! Feel free to sand, or touch up the hand details with a dremel tool.