Macbeth Prop Knife Parts

These are parts of a prop knife my group and I will be using for a skit on Shakespeare's "Macbeth". I made it in 30-45 minutes and could have done something better if I cared more. I just needed a knife to literally sit on the ground so that I, the actor for Lennox, could blame the death of King Duncan on the guards because their dagger(s) were covered in blood. Important Info: - Can be 3D printed. **HOWEVER!!! AND THIS IS VERY IMPORTANT!!!** I had to **upscale** the model in Ultimaker Cura before I printed the parts. The final print time should say **3 hours and 4 minutes**!!! - The little boxes sticking out of the two hilt parts are there for the alignment of the blade and handle parts. However, when printed, they get flatter than intended so you'll have to **remove ONE from the TOP** and **ONE from the BOTTOM!!!** COMPLETED: *Feburary 20, 2022* Model Created (Sloppily) By: *Knoxlava*